Troy-Bilt Ride On
13A726JD066
Features
Model
CR12Lawn Tractor
Engine
Troy-Bilt
Deck Cutting Width
30 Inches
Updating ...
If you do not see your manual in the list below, please feel free to contact us for further assistance at
Model | Manual | Form Number | Download operator's manual | ||
---|---|---|---|---|---|
13A726JD066 | MOWER:MINI LT:30SD 6SPD J STYL | ||||
MAN:OWN:COL3X_382CC-439CC_ENG | 769-17451 | PDF Version | |||
MAN:OWN:COL3X_382CC_ENG | 769-11782A | PDF Version | |||
MAN:OWN:COL3X_382CC_ENG | 769-11782B | PDF Version | |||
MANL:OPER:BILING:CR12 MINI | 769-11837 | PDF Version | |||
MANL:OPER:BILING:CR12 MINI | 769-11837A | PDF Version | |||
MANL:OPER:BILING:CR12 MINI | 769-12502A | PDF Version | |||
MANL:OPER:BILING:CR12 MINI | 769-17694 | PDF Version | |||
SHEET:SUP:BILING:EPA:CARB:EXH: | 769-15174 | PDF Version | |||
SHEET:SUP:BILING:EPA:CARB:EXH: | 769-17172 | PDF Version | |||
SHEET:SUP:BILING:EPA:EVP:06301 | 769-15171 | PDF Version | |||
SHEET:SUP:BILING:EPA:EVP:18-19 | 769-17171 | PDF Version | |||
SHEET:SUPP:CR12 HITCH | 769-12082 | PDF Version | |||
SHEET:SUPP:WARR/PARTS:TB CR12 | 769-11841 | PDF Version | |||
SHEET:SUPP:WARR/PARTS:TB CR12 | 769-12504 | PDF Version | |||
SHEET:SUPP:WARR/PARTS:TB CR12 | 769-17771 | PDF Version |
How To's
-
No Support Articles Found
Maintenance Schedule
Before Each Use
- Check engine oil level by using the dipstick
- Always use fresh fuel when filling the equipment's gas tank
- Check air filter for dirty, loose or damaged parts
- Inspect and clean around muffler to remove dirt build-up. Accumulation of debris around the muffler could cause a fire
Every 10 Hours
- Check engine oil level
- Keep battery cables and terminals clean and free of corrosive build-up. After cleaning apply a light coat of petroleum jelly or grease to both terminals
Every 25 Hours of Use
- Clean and re-oil air filter's foam pre-cleaner (if equipped)
- Remove front and rear wheels;lubricate the axles and the rims well with an all-purpose grease before re-installing them
- Clean engine cooling fans with a brush or compressed air
- Lubricate the steering rack and pinion gear located under the front of the unit
Every 50 Hours of Use
- Change engine oil
Every 100 Hours of Use
- Replace air filter
- Check spark plug condition and gap using a feeler gauge
Every Season
- Lubricate all the pivot points on the drive system, parking brake and lift linkage with light oil
- Lubricate the axles and the rims with an all-purpose grease before re-installing them
Prior to Storing
- Run engine try of fuel or use a fuel stabilizer
- Remove battery, clean battery terminals and hook up to trickle charger
- Lubricate axles and rims
- Clean engine cooling fans
- Check spark plug condition and gap