How to Store Your Troy-Bilt Riding Lawn Mower in the Off Season
This article will tell you how to prepare your Troy-Bilt riding lawn mower for off season storage. Depending on your model, the instructions may vary slightly. Always be sure to check your operator's manual for detailed instructions.
- Step 1
Be sure the mower is on a flat, level surface. Turn the engine off and make sure it is cool.
- Step 2
Remove the red cable, then the black cable from the battery. Do not allow the wrench to come in contact with any metal.
- Step 3
Remove the battery from the lawn mower and store it in a warm and dry place.
- Step 4
Replace worn or damaged spark plugs.
- Step 5
Check your old spark plugs or your operator's manual for the correct part number.
- Step 6
Change the oil and replace the filter.
- Step 7
Clean the oil fill and drain area of any debris.
- Step 8
Remove the dip stick from the oil fill tube. Then using the Arnold Siphon Pump, place the black tube into the dip stick hole on the engine and the orange tube into the oil pan.
- Step 9
Prime the pump by pumping the handle three to four times. Once the liquid begins to flow, it will flow without further pumping.
- Step 10
Remove the Arnold Siphon Pump.
- Step 11
Remove the oil filter. Using oil, lubricate the gasket of the new filter, then install the filter.
- Step 12
Add new oil as instructed in your operator's manual.
- Step 13
Replace the dip stick. Wait several minutes, then use the dip stick to check oil level.
- Step 14
Replace the air filter.
- Step 15
Remove the air cleaner cover from the mower. Then, remove the paper and foam elements.
- Step 16
Wash the foam element in mild detergent and water and allow it to dry completely.
- Step 17
Apply a few drops of clean engine oil to the foam element and squeeze out all excess oil.
- Step 18
Replace the new paper element and the foam element in the air cleaner cover.
- Step 19
Clean the undercarriage of dirt, grass clippings and any other objects that may have become lodged there.
- Step 20
Wearing gloves for protection, inspect your blades for wear or damage. Use the Arnold Blade Removal Tool to hold the blades in place.
- Step 21
Then, using a socket, loosen the bolt securing the cutting blade to the spindle. Remove the blades.
- Step 22
Assemble the new blades and blade adapters on the engine spindle and tighten the bolts to the proper torque as indicated in your operator's manual.
- Step 23
If your blade only needs sharpening, use the Arnold Blade Sharpener and Balancer Kit.
- Step 24
Remove the Arnold Blade Removal Tool.
- Step 25
Check the mower for any broken or worn parts including belt covers, belts, discharge chute, deck wheels and tires. Replace any of these worn or broken parts with the right replacement parts as noted in your operator's manual.
- Step 26
Finally, add a fuel stabilizer to the fuel tank to prevent fuel from spoiling while the mower is not in use.