How to Change the Gas in Your Troy-Bilt Edger
Length of Clip: 1:02
This video will show you how to change the gas on this Troy-Bilt edger. Depending on your model, the instructions in this video may vary slightly. Always be sure to check your operator's manual for detailed instructions.
Instructions
- Step 1
Disconnect the spark plug ignition wire.
- Step 2
Unscrew the gas cap.
- Step 3
Using the Arnold Siphon Pump, place the top hose into the gas tank on the engine, and the bottom hose into a proper container.
- Step 4
Prime the pump by pumping the handle three to four times. Once the liquid begins to flow, it will flow without further pumping.
- Step 5
Remove the Arnold Siphon Pump and add new gas.
- Step 6
Replace the gas cap.
- Step 7
Reconnect the spark plug ignition wire.
- Step 8
Dispose of gas properly.
Did you find this helpful?
http://img.youtube.com/vi/jOTAQe6Yh3Q/1.jpg





